Aquantia AQC107, AQC108, Firmware Version 3.1.56

Okay, thanks.
In summary:
Unplug the ethernet cable going to the Aquantia LAN port.
Use "diag -k -p" to first check the existing firmware version.
Use "diag -k -f DellNormalDirtyWake-3.1.56_bdp.clx --phy_flash_bdp" to perform the flash.
Shut down the system, use the PSU rocker switch to turn off power, then press and hold the front case power button for a few seconds.
Flip the PSU power switch back on and reboot Windows.
Go to Device Manager and uninstall the Sources/Aquantia device.
Re-install the Aquantia device driver, and check that it is again present under Network Adapters.
Plug in the ethernet cable.

i have a AQC111C on my mobo i use the instractions and its bricked



C:\Users\Johnny Fire\Desktop>diag -k -f DellNormalDirtyWake-3.1.56_bdp.clx --phy_flash_bdp
PCI\VEN_1D6A&DEV_11B1&SUBSYS_87721043&REV_02\4&261959&0&00E5: Disabled
1 device(s) disabled.
PCI\VEN_1D6A&DEV_11B1&SUBSYS_87721043&REV_02\4&261959&0&00E5: Enabled
1 device(s) enabled.

FLASH type = Macronix MX25L32
PHY could not be detected!
FLASH type = Macronix MX25L32
Bytes: 0x20000
Bytes: 0x20000
Bytes: 0x40000
Kickstarting MCP
FLASH type = Macronix MX25L32
Error kickstarting (mac = False, phy = True)!



now the ethernet not working when drivers installed has an ! and the firmware ver is 0 0 please help me

Look in Windows Device Manager for an Aquantia device under "Sources" & uninstall that device.
Then re-run the Aquantia LAN port driver installation utility.
Latest version: 2.1.16.0
www.station-drivers.com/index.php?option...info&id=3822&lang=en
Then check under Network Adapters, where the Aquantia Network Adapter should have re-appeared.

its not that i already dont everyting i can the ethernet is bricked and need to be reflash somehow please anyone?

JohnnyFire écrit: its not that i already dont everyting i can the ethernet is bricked and need to be reflash somehow please anyone?

Don't panic, it's due to a special Aquantia diagnostic device driver which got installed (via "diag -k") before flashing the firmware.
Which should be manually uninstalled in order to regain use of port.
See previous message.