Nouveau firmware pour le controller Usb 3.0 Renesas/Nec uPD720200A qui passe de la version 4.0.1.5.0.2 a la version 4.0.2.0.
La mise à jour peut être faite soit sous Windows ou Ms-Dos.
Recapitulatif des firmwares Usb 3.0 de Renesas/Nec disponibles:
- uPD720200 Version 3.0.2.8.0.8
- uPD720200A Version 4.0.2.0
- uPD720201 & 720202 Version 2.0.1.4
Voici les améliorations apportées (Anglais):
1. Fixed the USB3.0 Host Controller in D3hot didn't send the PME Message
when it received any wakeup events.
2. The following issue is fixed by ver 2.1.19.0 of RENESAS USB 3.0 Host
Controller Driver, but there was a possibility that this could still
occur in Windows 8:
[RENSAS USB 3.0 Host Controler Driver ver 2.1.19.0's history]
1. USB3.0 devices aren't detected when users perform the below steps.
a) Turn on a PC.
b) Enter sleep (S3 state) without connecting USB3.0 devices.
c) Connect USB3.0 devices to a USB3.0 port during S3 state.
d) USB 3.0 HDD isn't detected.
The USB3.0 devices aren't detected after the PC resumes from S3 state.
With Windows 7 or earlier, this issue only occurs with driver Ver.2.1.16.0.
3. There is a possibility that the USB 3.0 Host controller cannot notify
the xHCI Driver when the Host controller receives the following contiguous
Device Notification Transaction Packets: Function Wake Notification,
Latency Tolerance Message (LTM) Device Notification, Bus Interval Adjustment
Message Device Notification.
We have never seen this problem on a real system.
4. Improved the interoperability of UAS devices in Windows 8.
5. The following issue is fixed by ver 2.1.19.0 of RENESAS USB 3.0 Host
Controller Driver, but there was a possibility that this issue could
still occur in Windows 8:
[RENSAS USB 3.0 Host Controler Driver ver 2.1.19.0's history]
2. There is a possibility of bluescreen caused by Hot-Plug operation of a
USB3.0 Hub connecting USB3.0 devices. With Windows 7 or earlier, this issue only occurs
with Ver 2.1.16.0.
6. Failed the TD7.3 of Link Layer test by using Ellisys Version : 2.0.4210
and Lecroy Version F 1.35 Build107 or later.
This issue arose from changing the Link Layer test specification.
Merci a Simon pour l'info
N'hesitez pas a laisser vos commentaires, merci.
Téléchargement (Download)
http://www.station-drivers.com/page/renesas.htm
